8641 East 30th Street Indianapolis IN 46219 US 

 (317) 890-0100          division7mtls@division7mtls.com

DIVISION 7 ALUMINUM COMPOSITE PANEL SYSTEMS

The D7-105 is a route and return aluminum composite panel system using integral locking extrusions with sealed joints between panels.  The wet seal system keeps water out of the panel system and away from your building.

Our system has been independently tested and meets the highest standards in the industry.  

Division 7 Mtls, LLC

Contact Us

The D7-1 FPS is an exposed extrusion wall cladding system that is simple to install and easily field modified to adapt to field conditions.  The system is offered in reveal and non-reveal type extrusions to give your building the look you require.  Extrusions are finished to either match the color of the ACM panels or can be any color combination you may desire.  This design allows us to provide a simple, packaged system, adaptable on the job site for fast installation

The D7-FUSION  is a route and return aluminum composite panel system using FUSION DRILL FREETM extrusions and filler strips between panels. It is designed to speed fabrication and provide a user friendly installation. The system uses custom extruded aluminum framing and pre-drilled wall mounted clips integral to the frame extrusions for a secure attachment to your substrate. This system has been independently tested and meets the highest standards in the industry. 

Division is the only factory authorized fabricator of the Fusion System in the state of Indiana.

The D7-100 is a route and return aluminum composite panel system using filler strips between panels. 

It is designed for ease in installation and provides a truly finished look to any facade.  

The system uses extruded aluminum framing and wall mounted clips for a secure attachment to your substrate.

Our system has been independently tested and meets the highest standards in the industry.  

Working with you

​from the ground up!